![]() NEVER allow small children near batteries.To prevent possible SERIOUS INJURY or DEATH: The keypad will blink twice when the one button close feature is activated.To activate the one button close feature: The keypad will blink four times when the one button close feature is deactivated.Press and hold the 1 and 9 buttons for 10 seconds.To deactivate the one button close feature: NOTE: This feature is not available on garage door openers manufactured prior to 2006 or an external receiver. ONE BUTTON CLOSE: The Keyless Entry has a feature that allows the door to be closed using the ENTER button instead of a PIN. The Keyless Entry will transmit only the last four digits that were pressed before the ENTER button. If the wrong number is accidentally pressed, press the correct PIN then the ENTER button. The keypad will blink for 15 seconds, during that time the ENTER button can be used to stop, start or reverse the door. The garage door opener activates when the PIN and ENTER button are pressed. Do not overtighten to avoid cracking the plastic housing. Mark the bottom hole and drill 1/8 inch (3.2 mm) pilot hole.Position the Keyless Entry over the top screw. Install the top screw, allowing 1/8 inch (3.2 mm) to protrude above the surface.Mark the top mounting hole and drill 1/8 inch (3.2 mm) pilot hole.Select a location to mount the Keyless Entry at a minimum height of 5 feet (1.5 m) out of the reach of children.To clear the temporary PIN, repeat steps 1-3 above, setting the number of hours or openings to 0 in step 3. If the temporary PIN was set for a number of openings, the test will use up one opening. To test, press the temporary PIN, then press the ENTER button. Press the number of openings the temporary PIN w ill work (up to 255). ![]() Press the number of hours the temporary PIN will work (up to 255). Enter the temporary 4-digit PIN of your choice, then press the ENTER button.Press any programmed PIN, then press and hold the * button until.the light bulb blinks 3 times.The temporary PIN cannot be the same as any previously programmed PIN. The temporary PIN can be set for a number of hours or a number of door openings. Each programmed PIN can program one temporary PIN. ![]() NOTE: This feature is not available on garage door openers that have a green Learn button or an external receiver.Ī temporary 4-digit PIN can be programmed to allow access to visitors. To test, press the new PIN, then the ENTER button.Enter the new 4-digit PIN of your choice, then press the ENTER button.Press and hold the # button until.the light bulb blinks twice.Press the programmed PIN that you want to change.* For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN. To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener. To test, press the PIN, then press the ENTER button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |